Non-chemical water treatment, delivered with measurable outcomes.
A practical approach to limescale management that doesn't rely on chemicals, salt, or dosing — with structured evidence and reporting built in.
The approach
CarbonCare applies a treatment signal to designated pipework via cable coils. This is typically installed at the rising main and, where appropriate, at secondary hot water return loops to support treatment across the system.
The technology works by influencing how calcium carbonate crystallises, encouraging it to form in suspension rather than adhering to pipe surfaces and heat exchange equipment.
Typical installation points
Rising main
Primary treatment point for incoming supply
Secondary hot water returns
Extended treatment for circulation loops
Key branches
Additional coverage where required
What clients typically see
Outcomes vary by site, but these are the improvements we commonly observe and measure
Reduced hard-scale build-up
Behaviour change over time in how scale forms and adheres
Easier cleaning
Less aggressive descaling interventions required
Improved heat transfer
More consistent performance from heat-transfer equipment
Reduced maintenance
Fewer unplanned maintenance events (site dependent)
What makes it practical
Designed for minimal disruption and ongoing operational simplicity
Important notes
Setting expectations clearly
- 1Results depend on system condition, hardness, temperatures, and flow patterns.
- 2Reporting shows assumptions and ranges — not promises.
- 3Water safety compliance remains a managed process; CarbonCare supports good system condition and cleanliness alongside existing regimes.
Ready to see if it fits your site?
Upload your drawings for a budget estimate, or book a survey to discuss your system in detail.
We'll review your inputs and return recommended next steps